(9) A red letter L displayed on the dumb-bell specified in paragraphs (4) and (5), as illustrated in this paragraph, Signifies that helicopters shall take off and land only within the area designated by the marking specified in rule 59(7). (8) A white letter H, as illustrated in this paragraph, Signifies that the aerodrome is unsafe for the movement of aircraft and that landing on the aerodrome is prohibited. (7) A red panel 3 metres square with a yellow strip 50 centimetres wide along each diagonal, as illustrated in this paragraph, Signifies that the state of the manoeuvring area is poor and pilots must exercise special care when landing. (6) A red panel 3 metres square with a yellow strip along one diagonal 50 centimetres wide, as illustrated in this paragraph, The shaft of which is one metre wide and which is placed along the whole or a total of 11 metres of two adjacent sides of the signals area, and pointing in a clockwise direction, signifies that a right-hand circuit is in force. (5) A red and yellow striped arrow, as illustrated in this paragraph, Signifies that aeroplanes and gliders taking off or landing shall do so on a runway but that movement on the ground is not confined to paved, metalled or similar hard surfaces. Signifies that movements of aeroplanes and gliders on the ground shall be confined to paved, metalled or similar hard surfaces.Ī white dumb-bell, as described in paragraph (4), but with a black strip 60 centimetres wide across each disc at right angles to the shaft of the dumb-bell, as illustrated in this paragraph, (4) A white dumb-bell, as illustrated in this paragraph, Signifies that the direction of landing and take off do not necessarily coincide. (3) A white disc 60 centimetres in diameter displayed alongside the cross arm of the T and in line with the shaft of the T, as illustrated in this paragraph, Signifies that aeroplanes and gliders taking off or landing shall do so in a direction parallel with the shaft of the T and towards the cross arm, unless otherwise authorised by the appropriate air traffic control unit. (2) A white landing T, as illustrated in this paragraph, Signals in the Signals Areaĥ7.-(1) Whenever any signal specified in this rule is displayed it shall be placed in a signals area, which shall be a square visible from all directions bordered by a white strip 30 centimetres wide and with the internal sides measuring 12 metres. (2) Apart from those referred to in rule 60(6) and the distances at which markings must be placed, all dimensions of signals or markings specified in this Section of these Rules shall be subject to a tolerance of 10 per cent, plus or minus. Shall have the meaning assigned to it in this Section. (c) at any other place which is being used by aircraft for landing or take-off, SECTION 9 AERODROME SIGNALS AND MARKINGS-VISUAL AND AURAL SIGNALS Generalĥ6.-(1) Within the United Kingdom any signal or marking which is specified in this Section and which is given or displayed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |